MEMS Tiltsensor

mems 710x458 crop



The MEMS Tiltsensor is based on the itmsoil In-Place Inclinometer (IPI) sensor and is designed for attaching to structures where a large tilt range is required.

Mounted within the Stainless Steel housing are one or two (uniaxial or biaxial) MEMS sensors that deliver a large measuring range with high sensitivity and relative immunity from the effects of long cable lengths.

The MEMS Tiltsensor is a small discrete device which measures in g (gravity), providing reliable, accurate and stable data.

Each sensor incorporates an on-board microprocessor which performs an automatic temperature compensation of the tilt (g) data.

The sensors are powered and the readings obtained by a datalogger. The data can be directly imported into ‘Argus’ monitoring software, providing a near real time profile of displacement that is constantly updated.

Product Features
  • Accurate and precise measurements using MEMS sensors
  • Available in uniaxial and biaxial versions
  • Inbuilt temperature compensation
  • Stainless Steel construction, waterproof to 2000kPa
Product Benfits
  • Easy to automate using data acquisition systems and ‘Argus’ software
  • Removes the need for manual monitoring
  • Suitable for safety critical applications
  • Low power consumption



Once the location for the MEMS Tiltsensor has been established the position is marked out, ensuring that the sensor is correctly orientated towards the direction of movement.

The marked locations are drilled to depth and the 8mm shell anchors supplied with the Tiltsensor are installed. Studding is screwed into the shell anchors, leaving a sufficient length to incorporate the bracket and the Tiltsensor.

Once the studding is in place, the Tiltsensor bracket is mounted on to the studding, ensuring there is an adequate space between the structure and the Tiltsensor before securing in place using the M8 washers and nuts.

A spirit level is used to check that the Tiltsensor is level in both directions, and then the nuts are securely tightened before the Tiltsensor is finally wired into a datalogger.

The system can be fully automated using ‘Argus’ monitoring software, providing a near real time profile of displacement. 



The MEMS Tiltsensor monitors vertical rotations of structures. Its most common use is to monitor settlement and heave of existing structures and tunnels caused by adjacent excavations or tunnelling works.

The sensor is especially useful where topographic measurements are precluded or where access is restricted.

Typical monitoring applications include:

  • Brick and stone buildings
  • Vertical rotation (heave and settlement) due to adjacent construction activities
  • Bridges and dams
  • Impounding and loading effects in short or long term
  • Differential levels
  • Tunnels
  • Monitoring vertical rotation and track formation


TLT-6 - MEMS Tiltsensor Datasheet

Click here to download [PDF]

This downloadable PDF is the new itmsoil datasheet.




Western Australia

Perth Office

209/396 Scarborough Beach Road
Osborne Park
WA 6017


New South Wales

Sydney Office

Unit 137, 18 Buchanan Street
NSW 2041

t: +61 (0) 8 9284 0244
f: +61 (0) 8 9284 0233
  t: 1300 884 542